8 CH FLICKER & FLAME EFFECT

CONTROLLER PHOTOS

FOR LOW VOLTAGE DC APPLICATIONS
This is the 8 channel Flicker effect PC board ready for mounting in a suitable enclosure. An extra heatsink may be attached to the main heatsink if extra power handling capacity is desired. Flicker intensity is selected with the 4 section DIPswitch in the lower right hand corner, and the potentiometer is used to adjust the speed of the effect.
Power Supply and load connections are made to the ten terminals at the back of the PC board. The jumper on the left side is for selection of DC system power supply voltage. The controller will operate with unfiltered DC directly from a bridge rectifier. This allows operation from existing 12, 24, 32, or 36 volt AC power sources by using an inexpensive bridge rectifier. The LEDs visually indicate the generated light effects and also serve to check for correct operation.
BACK    APPLICATIONS
 
NORTH COUNTRY RADIO
PO Box 200, Hartford NY 12838-0200
EMAIL: support@northcountryradio.com            Tel 518-854-9280           Internet http://www.northcountryradio.com